Face Runout (Axial Eccentricity) of the Flywheel Illustration 1 g02166614 Checking face runout of the flywheel (1) 7H-1645 Holding Rod (2) 7H-1945 Holding Rod (3)…

Note: The following procedure does not require the use of an H bar to hold the liners while the liner projection measurements are taken. The…

Illustration 1 g01102463 (1) Adjustment screw (2) Adjustment screw locknut (3) Intake rocker arm (4) Actuator rod Put the No. 1 piston at the top…

Note: Valve lash is measured between the rocker arm and the valve bridge. All measurements and adjustments must be made with the engine stopped and…

An engine that runs roughly can have a leak at the valves. An engine that runs roughly can also have valves that need an adjustment.…

Static Check of the Timing Gear Position Illustration 1 g01106267 Front gear group (1) Timing marks (2) Camshaft gear (3) Adjustable idler gear (4) Idler…

The No. 1 piston at top center (TC) on the compression stroke is the starting point of all timing procedures. Note: Some engines have two…

Cylinder Block Assembly Passages supply the lubrication for the crankshaft bearings and the piston crowns. These passages are drilled passages in the oil manifolds. Cooling…

Removal Procedure Drain the coolant. Refer to Operation and Maintenance Manual, “Cooling System Coolant (ELC) – Change” for the correct draining and filling procedures. Illustration…

Removal Procedure Start By: Remove the hydraulic manifold that controls the combustion air valve. Illustration 1 g01880583 Note: Cleanliness is an important factor. Before the…