(1) Depth of bore in block for liner … .401 ± .001 in.(10.19 ± 0.03 mm)
Height of liner over block (under installation pressure) … .0020 to .0056 in.(0.051 to 0.142 mm)
(2) Bore in block for camshaft bearing … 2.5630 ± .0010 in.(65.100 ± 0.025 mm)
(3) Bore in block for main bearing … 3.8160 ± .0005 in.(96.926 ± 0.013 mm)
(4) Torque for bolts holding caps for main bearings:
a. Put crankcase oil on threads and washer face.
b. Tighten all bolts to … 30 ± 3 lb.ft.(4.1 ± 0.4 mkg)
c. Put a mark on each bolt and cap.
d. Tighten all bolts from mark … 90°
(5) Bore in block for balancer bearing (4 cylinder only) … 2.2776 ± .0010 in.(57.851 ± 0.025 mm)