(1) Grease fitting. Fill bearing cavity with 20 grams (0.7 ounces) of 2S3230 Bearing Lubricant. (2) Bracket. Assembly procedure for bracket a. Tighten bolt (4)…
Tag: 3116
Removal Procedure 1.Remove bolts (2), crankshaft vibration damper (3), and spacers from the crankshaft pulley. Note: For information on the reusability of the vibration damper…
Installation Procedure 1.Thoroughly clean the mating surfaces of the cylinder head and the cylinder block. 2.Visually inspect the bolt holes for the cylinder block for…
Removal Procedure Start By: A.Remove the fuel filter base. Refer to Disassembly and Assembly, “Fuel Filter Base – Remove and Install”. B.Remove the unit injectors.…
Removal Procedure Table 1 Required Tools Tool Part Number Part Description Qty A (1) …
Removal Procedure Start By: A.Remove the inlet valves and the exhaust valves. Refer to Disassembly and Assembly, “Inlet and Exhaust Valves – Remove and Install”.…
Removal Procedure Start By: A.Remove the cylinder head assembly. Refer to Disassembly and Assembly, “Cylinder Head – Remove”. Note: For information on the reusability of…
Installation Procedure 1.Inspect the injector sleeve for pitting and for carbon tracking. Used injector sleeves do not need to be reamed unless the seated…
Removal Procedure Start By: A.Remove the unit injector. Refer to Disassembly and Assembly, “Unit Injector – Remove”. 1.Use Tooling (A) to remove unit injector sleeve…
(1) Large bolts (M20) (2) Small bolts (M10) Instructions for installing bolts (1) and (2): Put engine oil on the threads of the bolts and…