General Information Illustration 1 g00719183 Rest Position (1) Return Spring (2) Solenoid (3) Pull-In Winding (4) Start (S) Terminal (5) Hold-In Winding (6) Battery (Bat)…
Tag: 3116
Illustration 1 g00718697 (1) Rear Housing (2) Solenoid (3) Plunger (4) Shift Lever Housing (5) Shift Lever (6) Drive Housing (7) Pinion Drive (8) Brushes…
Illustration 1 g00717738 42-MT Starting Motor The heavy-duty starting motors are offered in 24Vand 12V versions. The 37-MT and 41-MT are similar in operation and…
The following procedure is used in order to perform the no-load test after the starting motor has been repaired. The test should also be performed…
Installation Procedure Illustration 1 g00614182 1.Clean surface (7) . 2.Inspect the condition of the O-ring seals. Replace the seals, if necessary. Illustration 2 g00614173 3.Install…
Assembly Procedure Illustration 1 g00614283 1.Install the shaft and the bearing into pulley (3) with a press. Install the shaft until the shaft is flush…
Disassembly Procedure Start By: A.Remove the water pump. Refer to Disassembly and Assembly, “Water Pump – Remove”. Illustration 1 g01026865 1.Remove rear cover (1) .…
Removal Procedure Start By: A.Remove the belt tensioner. Refer to Disassembly and Assembly, “Belt Tensioner – Remove and Install”. 1.Drain the coolant from the cooling…
Idler Pulley Assembly (1) Distance from back of plate assembly (3) to middle of pulley (4) … 26.0 ± 0.3 mm (1.02 ± 0.012 in)…
Shown With Impeller Cover Removed (1) Clearance between impeller and housing … 0.75 ± 0.25 mm (0.030 ± 0.010 in) (2) Seal. (3) Working height…