Introduction This Special Instruction provides guidelines and instructions for use of Cat Coolant Conditioner for Aluminum Unit Core Radiators, and Aluminum Modular Core Radiators. For…
Author: sam
Introduction This Special Instruction provides the necessary information on all welding procedures. Proper Cleaning for Inspection Before you inspect the area, clean the area…
Introduction Procedure to prevent injector Plunger Spring failure due to inadequate fuel system priming. The low-pressure fuel system must be primed after injector replacement…
Caterpillar Products: All (Except Unregulated, Tier 0, Tier 3, and Tier 4 Engines) Introduction NOTICE Diesel Particulate Filters (DPF) are not applicable…
Asphalt Paver: AP-1000D (S/N: EAD1-UP) AP-1055D (S/N: FAC1-UP; A6P1-UP) BG-2455D (S/N: BNW1-UP; BXW1-UP) BG-260D (S/N: BPW1-UP) Engine: C7 (S/N: JRA1-UP; JTF1-UP) Marine Engine: C7 MARINE…
A failed water pump might cause severe engine overheating problems that could result in the following conditions: Cracks in the cylinder head A piston…
Periodic inspection and cleaning are recommended for the turbocharger compressor housing (inlet side). Any fumes from the crankcase are filtered through the air inlet system.…
Severe service is an application of an engine that exceeds current published standards for that engine. Caterpillar maintains standards for the following engine parameters: …
Note: Adjust the frequency of cleaning according to the effects of the operating environment. Inspect the radiator for these items: damaged fins, corrosion, dirt, grease, insects,…
Reduced hours of operation at full load will result in a lower average power demand and reduced fuel consumption. A decreased average power demand should…