C3.3B – Fuel Injection Pump and Governor – Assemble

Assembly Procedure

Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     390-1150     Injection Pump Gear Puller     1    
154-6360 Bolt     1    
B     8H-0663     Bearing Puller     1    

Note: Refer to Specification UENR0995 "Engine Design" for non-specified engine Torque Values.




    Illustration 1g02805765



    Illustration 2g02807019



    Illustration 3g02807020

  1. Use Tooling (B) and a suitable press to install bearings (26) onto fuel camshaft (24) .

  1. Position ring (27) . Use Tooling (B) and a suitable press to install bearings (25) onto fuel camshaft (24) .



    Illustration 4g02805716

  1. If necessary, replace key (23) with new. Position retaining plate (22) and install screws (21) . Tighten screws (21) to a torque of 3.9 to 4.2 N·m (34.5 to 37.4 lb in).

  1. Position fuel camshaft (24) in the housing assembly.

  1. Position retaining plate (20) and install bolts (19) . Tighten bolts (19) to a torque of 10 to 11 N·m (87 to 100 lb in).



    Illustration 5g02805660

  1. Install gear (18) .

  1. Install nut (17) to gear (18) .

  1. For the C3.3B Tighten nut (17) to a torque of 138 to 156 N·m (102 to 115 lb ft).

  1. For the C2.6 Tighten nut (17) to a torque of 93 to 102 N·m (69 to 75 lb ft).



    Illustration 6g02805658



    Illustration 7g02805656

  1. Position governor weights (15) and install nut (16) . Tighten nut (16) to a torque of 63 to 72 N·m (47 to 53 lb ft). Install governor sleeve (14) .



    Illustration 8g02805641

    Note: Apply engine oil to all internal parts of governor.

  1. Install O-ring seals on governor lever assembly (13) . Position governor lever assembly (13) into the governor housing and install spring (12) .

  1. Install spring (11) and speed control lever (9) on governor lever assembly (13) .

  1. Install pin (10) into governor lever assembly (13) .



    Illustration 9g02805640

  1. Position governor lever (8) . Install shaft (6) and spring (7) in governor housing assembly (3) .

  1. If necessary, replace O-ring seal (5) with new. Install O-ring seal (5) in governor housing assembly (3) .



    Illustration 10g02805639

  1. Use a suitable blocking to support the fuel injection pump and governor. Position governor housing assembly (3) and install bolts (4) . Tighten bolts (4) to a torque of 10 to 11 N·m (87 to 100 lb in).

Leave a Reply

Your email address will not be published. Required fields are marked *