Removal Procedure
Start By:
- Remove the cylinder head. Refer to Disassembly and Assembly, “Cylinder Head – Remove”.
- Remove the engine oil pump. Refer to Disassembly and Assembly, “Engine Oil Pump – Remove”.
- Remove the piston cooling jets. Refer to Disassembly and Assembly, “Piston Cooling Jets – Remove and Install”.
- Turn the crankshaft until the connecting rod caps are at the bottom center.
- Place a identification mark on the connecting rod and connecting rod cap (2). The number should match the cylinder number.
- Remove bolts (1) and connecting rod cap (2) .