Tag Archives for turbocharger

3116 and 3126 Truck Engines Turbocharger Adjusting

The turbocharger senses boost pressure which actuates the wastegate valve which will control the amount of exhaust gas that will be allowed to bypass the turbine side of the turbocharger. The speed of the turbocharger is controlled by the wastegate … Continue reading

26. July 2017 by sam
Categories: 3126 | Tags: , , , | 1 comment

3100 HEUI Diesel Truck Engine Turbocharger

Turbocharger (1) Air inlet. (2) Compressor housing. (3) Compressor wheel. (4) Bearing. (5) Oil Inlet port. (6) Bearing. (7) Turbine housing. (8) Turbine wheel. (9) Exhaust outlet. (10) Oil outlet port. (11) Exhaust inlet. The turbocharger is installed on the … Continue reading

24. July 2017 by sam
Categories: 3126 | Tags: , , , | Leave a comment

3116 and 3126 Truck Engines Turbocharger – Install

Installation Procedure 1.Inspect the turbocharger gasket for wear or damage. If the turbocharger gasket is worn or damaged, use a new part for replacement. 2.Apply Tooling (A) on the threads of the mounting studs for the turbocharger. 3.Position the turbocharger … Continue reading

16. July 2017 by sam
Categories: 3126 | Tags: , , | Leave a comment

3116 and 3126 Truck Engines Turbocharger – Assemble

Assembly Procedure 1.Position compressor housing (3) on cartridge assembly (2) and align the marks on the components. 2.Position turbine housing (1) on cartridge assembly (2) and align the marks on the components. 3.Install waste gate (5) . 4.Connect hose (4) … Continue reading

16. July 2017 by sam
Categories: 3126 | Tags: , , | Leave a comment

3116 and 3126 Truck Engines Turbocharger – Disassemble

Disassembly Procedure 1.Place alignment marks on the two housings and the cartridge assembly for the correct alignment during assembly. 2.Disconnect hose (4) from compressor housing (3) . 3.Remove waste gate (5) from turbine housing (1). 4.Remove turbine housing (1) . … Continue reading

16. July 2017 by sam
Categories: 3126 | Tags: , , | Leave a comment

3116 and 3126 Truck Engines Turbocharger – Remove

Removal Procedure 1.Remove bolts (1) and the gasket. Remove bolts (3) and tube assembly (2) from the turbocharger. 2.Remove the bolts and the gasket in order to disconnect oil supply tube assembly (5) from the turbocharger. 3.Remove nuts (4), turbocharger … Continue reading

16. July 2017 by sam
Categories: 3126 | Tags: , , | Leave a comment

3116 and 3126 Truck Engines Turbocharger

Typical Example (1) Turbine housing. (2) Apply 5P3931 Anti-Seize Compound to threads of bolts that hold turbine housing to turbocharger. Tighten to a torque of … 15.8 ± 0.5 N·m (140 ± 4 lb in) (3) Cartridge. (4) Tighten bolts … Continue reading

15. July 2017 by sam
Categories: 3126 | Tags: , , | Leave a comment