Tag Archives for housing

3116 and 3126 Truck Engines Flywheel Housing – Remove and Install

Removal Procedure Start By: A.Remove the flywheel. Refer to Disassembly and Assembly, “Flywheel – Remove”. 1.Fasten Tooling (A) and a suitable lifting device to flywheel housing (1) . 2.Remove bolts (2) and bolt (3) that fastens flywheel housing (1) to … Continue reading

17. July 2017 by samuel07042012
Categories: 3126 | Tags: , , , | Leave a comment

3116 and 3126 Truck Engines Flywheel Housing Bore

Typical Example NOTE: Write the dial indicator measurements with their positive (+) and negative (-) notation (signs). This notation is necessary for making the calculations in the chart correctly. 1. Fasten the dial indicator to the flywheel so the anvil … Continue reading

17. July 2017 by samuel07042012
Categories: 3126 | Tags: , , , | Leave a comment

3116 and 3126 Truck Engines Flywheel Housing Runout

Face Runout (Axial Eccentricity) Of The Flywheel Housing: 8T5096 Dial Indicator Group Installed (Typical Example) 1. Fasten a dial indicator to the crankshaft flange so the anvil of the indicator will touch the face of the flywheel housing. 2. Put … Continue reading

17. July 2017 by samuel07042012
Categories: 3126 | Tags: , , , | Leave a comment

3116 and 3126 Truck Engines Flywheel Housing

Typical Example See the topics, Flywheel Housing Runout and Flywheel Housing Bore, for the correct methods of flywheel housing inspection. NOTE: Apply 1U8846 Gasket Maker to the entire cylinder block mounting face of the flywheel housing before assembling the flywheel … Continue reading

17. July 2017 by samuel07042012
Categories: 3126 | Tags: , , , | Leave a comment

3116 and 3126 Truck Engines Front Housing Cover

(1) Front Housing. (2) Front Housing Cover. On gasket to cover joint face (one side only) Clean cover face of gasket with solvent. Apply 1U8846 Gasket Maker to gasket and spread uniformly and around bolt holes. The cover must be … Continue reading

17. July 2017 by samuel07042012
Categories: 3126 | Tags: , , | Leave a comment

3116 and 3126 Truck Engines Front Housing

Block Mounting Face Before assembling front housing to cylinder block, apply approximately 15 mL (.5 oz) of 1U8846 Gasket Maker to entire area of surfaces (1) and (2) where they contact the cylinder block. Do not allow gasket maker to … Continue reading

17. July 2017 by samuel07042012
Categories: 3126 | Tags: , , | Leave a comment