Tag Archives for fan drive

3116 and 3126 Truck Engines Fan Drive – Install

Installation Procedure 1.Position fan drive (6) and front lifting group (7) on the cylinder head assembly. Install bolts (5) and the washers. 2.If equipped, position refrigerant compressor (4). Install bolts (3), the washers, and the nuts. 3.Position alternator bracket (1). … Continue reading

17. July 2017 by samuel07042012
Categories: 3126 | Tags: , , | Leave a comment

3116 and 3126 Truck Engines Fan Drive – Assemble

Fan Drive Assembly 1.Check the condition of O-ring seal (7) that is used in retainer (2). Check the condition of the roller bearing (8). If the components are damaged use new parts for replacement. 2.Install roller bearing (8) in bearing … Continue reading

17. July 2017 by samuel07042012
Categories: 3126 | Tags: , , | Leave a comment

3116 and 3126 Truck Engines Fan Drive – Disassemble

Disassembly Procedures Start By: A.Remove the fan drive. Refer to Disassembly and Assembly, “Fan Drive Remove”. 1.Remove bolts (1) and the fan drive pulley. 2.Remove bolts (6) and the washers from the bearing retainer (2) . Note: Access to bolts … Continue reading

17. July 2017 by samuel07042012
Categories: 3126 | Tags: , , | Leave a comment

3116 and 3126 Truck Engines Fan Drive – Remove

Removal Procedure Start By: A.Remove the alternator. Refer to Disassembly and Assembly, “Alternator – Remove and Install”. 1.Remove bolts (2) and remove alternator bracket (1) . 2.If equipped, remove bolts (3), the washers, and the nuts. Remove refrigerant compressor (4) … Continue reading

17. July 2017 by samuel07042012
Categories: 3126 | Tags: , , | Leave a comment

3116 and 3126 Truck Engines Fan Drive Specifications

(1) Grease fitting. Fill bearing cavity with 20 grams (0.7 ounces) of 2S3230 Bearing Lubricant. (2) Bracket. Assembly procedure for bracket a. Tighten bolt (4) finger tight (into water temperature housing). b. Tighten bolt (5) finger tight into bracket (3). … Continue reading

17. July 2017 by samuel07042012
Categories: 3126 | Tags: , , | Leave a comment