Tag Archives for EL-740

EL-740 Air Compressor Air Cleaner Inspection And Disassembly

1. Check the pressure drop across the air cleaner assembly. If the restriction is 1.2 kPa (20 inches of H2O) or greater the element should be replaced. 2. Examine the air cleaner cover. If bent, crushed or damaged replace with … Continue reading

01. August 2017 by samuel07042012
Categories: EL-740 | Tags: | Leave a comment

EL-740 Air Compressor Air Cleaner Removal-Bolt-On Type

1. Remove the two bolts holding the air cleaner to the cylinder block. 2. Remove the air cleaner and discard the gasket. Clean the gasket surfaces. Do not damage the machined surfaces. NOTE: Some air compressors do not have an … Continue reading

01. August 2017 by samuel07042012
Categories: EL-740 | Tags: | Leave a comment

EL-740 Air Compressor Governor Assembly Removal

The governor may be mounted to the cylinder head, cylinder block or end cap by means of a bracket, or remote mounted. Air Compressor Mounted Governor 1. Disconnect the unloader tube leading from the unloader assembly to the governor. 2. … Continue reading

01. August 2017 by samuel07042012
Categories: EL-740 | Tags: , | Leave a comment

EL-740 Air Compressor Service Procedure

Air inlet filters should be cleaned or replaced when the vacuum level exceeds 1.2 kPa (20 inches of H2O) at compression. The governor settings and the unloader operation should be checked regularly. Maximum desirable reservoir pressure for highway brake use … Continue reading

01. August 2017 by samuel07042012
Categories: EL-740 | Tags: , | Leave a comment

EL-740 Air Compressor General Description

The EL-740 Air Compressor is two cylinder, air or water cooled, and engine lubricated. It can be base or flange mounted. The air compressor has a rated capacity of 7.4 CFM which is the displacement in cubic feet per minute … Continue reading

01. August 2017 by samuel07042012
Categories: EL-740 | Tags: , , | Leave a comment