Tag Archives for cylinder head

EL-740 Air Compressor Cylinder Head Disassembly

1. Place the cylinder head in a soft-jawed vise, bottom side up. (1) Bushing. (2) Inlet valve guard and pin assembly. (3) Inlet valve. (4) Unloader pin. (5) Disc. (6) Cylinder head. (7) Washer. (8) Exhaust valve. (9) Exhaust valve … Continue reading

04. August 2017 by sam
Categories: EL-740 | Tags: | Leave a comment

EL-740 Air Compressor Cylinder Head Removal

1. Remove the six bolts holding the cylinder head to the cylinder block. 2. Tap the cylinder head lightly with a brass or plastic hammer to loosen. 3. Lift the head assembly off the cylinder head. 4. Remove and discard … Continue reading

04. August 2017 by sam
Categories: EL-740 | Tags: | Leave a comment

3116 and 3126 Truck Engines Cylinder Head – Install

Installation Procedure 1.Thoroughly clean the mating surfaces of the cylinder head and the cylinder block. 2.Visually inspect the bolt holes for the cylinder block for thread damage. 3.Install a new cylinder head gasket (3) . Note: To avoid damage to … Continue reading

17. July 2017 by sam
Categories: 3126 | Tags: , , | Leave a comment

3116 and 3126 Truck Engines Cylinder Head – Remove

Removal Procedure Start By: A.Remove the fuel filter base. Refer to Disassembly and Assembly, “Fuel Filter Base – Remove and Install”. B.Remove the unit injectors. Refer to Disassembly and Assembly, “Unit Injector – Remove”. C.Remove the water temperature regulator housing. … Continue reading

17. July 2017 by sam
Categories: 3126 | Tags: , , | Leave a comment

3116 and 3126 Truck Engines Cylinder Head

(1) Large bolts (M20) (2) Small bolts (M10) Instructions for installing bolts (1) and (2): Put engine oil on the threads of the bolts and tighten them as follows: a. Tighten bolt (1) through bolt (14) in a numerical sequence … Continue reading

17. July 2017 by sam
Categories: 3126 | Tags: , , | Leave a comment