Tag Archives for camshaft
3100 HEUI Diesel Truck Engine Camshaft
The camshaft is located in the upper left side of the block. The camshaft is driven by gears at the front of the engine. Seven bearings support the camshaft. A thrust plate is mounted between the camshaft drive gear and … Continue reading
3116 and 3126 Truck Engines Camshaft Idler Gear – Remove and Install
Removal Procedure Start By: A.Remove the front housing. Refer to Disassembly and Assembly, “Housing (Front) – Remove”. 1.Rotate the crankshaft until the number one piston is at the top center position. Timing mark (4) for camshaft idler gear (2) should … Continue reading
3116 and 3126 Truck Engines Camshaft Bearings – Remove and Install
Removal Procedure Start By: A.Remove the camshaft. Refer to Disassembly and Assembly, “Camshaft – Remove”. Note: Note the oil hole orientation in each camshaft bearing prior to removal for assembly purposes. 1.Use Tooling (A) to remove the camshaft bearings from … Continue reading
3116 and 3126 Truck Engines Camshaft Gear – Remove and Install
Removal Procedure Start By: A.Remove the camshaft. Refer to Disassembly and Assembly, “Camshaft – Remove”. 1.Wrap the camshaft with a protective covering in order to prevent damage to the camshaft. 2.Place camshaft (2) and camshaft gear (1) in a suitable … Continue reading
3116 and 3126 Truck Engines Camshaft – Install
Installation Procedure 1.Lubricate the camshaft and the camshaft bearings with clean engine oil. 2.Carefully install camshaft (4) and camshaft gear (1) in the engine. 3.Ensure that timing mark (5) on the camshaft gear is aligned with timing mark (6) on … Continue reading
3116 and 3126 Truck Engines Camshaft – Remove
Removal Procedure Start By: A.Remove the rocker arms and the pushrods. Refer to Disassembly and Assembly, “Rocker Shaft and Pushrod – Remove”. B.Remove the unit injector hydraulic pump. Refer to Disassembly and Assembly, “Unit Injector Hydraulic Pump – Remove”. 1.Remove … Continue reading
3116 and 3126 Truck Engines Camshaft
(1) Gear. Heat to install (do not use torch). Do not heat above … 316°C (600°F) (2) Distance between shoulder of camshaft and gear for thrust washer (new) … 4.83 ± 0.05 mm (0.190 ± 0.002 in) Thickness of thrust … Continue reading