(1) Front Housing. (2) Front Housing Cover. On gasket to cover joint face (one side only) Clean cover face of gasket with solvent. Apply 1U8846…
Block Mounting Face Before assembling front housing to cylinder block, apply approximately 15 mL (.5 oz) of 1U8846 Gasket Maker to entire area of surfaces…
(1) Camshaft idler gear. Distance between front face of bearing in gear bore and front face of gear (dimension A) … 0.40 ± 0.25 mm…
Installation Procedure Note: For information on the reusability of the flywheel on 3116 engines, refer to Guideline For Reusable Parts And Salvage Operations, SEBF8207, “Flywheel…
Removal Procedure Table 1 Required Tools Tool Part Number Part Description Qty A …
Face Runout (Axial Eccentricity) Of The Flywheel: Checking Face Runout Of The Flywheel (Typical Example) 1. Install the dial indicator as shown. Put a force…
Typical Example Refer to the topic, Flywheel Runout, for the correct method of flywheel inspection. (1) Apply 9S3263 Thread Lock to the threads of bolts…
Installation Procedure 1.Position fan drive (6) and front lifting group (7) on the cylinder head assembly. Install bolts (5) and the washers. 2.If equipped, position…
Fan Drive Assembly 1.Check the condition of O-ring seal (7) that is used in retainer (2). Check the condition of the roller bearing (8). If…
Disassembly Procedures Start By: A.Remove the fan drive. Refer to Disassembly and Assembly, “Fan Drive Remove”. 1.Remove bolts (1) and the fan drive pulley. 2.Remove…