Assembly Procedure 1.Position compressor housing (3) on cartridge assembly (2) and align the marks on the components. 2.Position turbine housing (1) on cartridge assembly (2)…
Disassembly Procedure 1.Place alignment marks on the two housings and the cartridge assembly for the correct alignment during assembly. 2.Disconnect hose (4) from compressor housing…
Removal Procedure 1.Remove bolts (1) and the gasket. Remove bolts (3) and tube assembly (2) from the turbocharger. 2.Remove the bolts and the gasket in…
Typical Example (1) Turbine housing. (2) Apply 5P3931 Anti-Seize Compound to threads of bolts that hold turbine housing to turbocharger. Tighten to a torque of…
Installation Procedure 1.Install the new gasket on the cylinder head. 2.Remove air inlet manifold (2) and bolts (1) . 3.Install bolts (1). Tighten the bolts…
Removal Procedure Start By: A.Remove the valve mechanism cover. Refer to Disassembly and Assembly, “Valve Mechanism Cover – Remove and Install”. 1.Disconnect air inlet piping…
Removal Procedure Start By: A.Remove the air inlet heater. Refer to Disassembly and Assembly, “Air Inlet Heater – Remove and Install”. B.Remove the fuel filter…
Typical Example Of A Three Piece Exhaust Manifold 1. Coat inside diameter of female ends of manifold with engine oil. 2. Apply a thin coat…
Typical Example (1) Air inlet elbow. On elbow joint-face, clean face with solvent and apply 6V1541 Quick Cure Primer. Allow primer to air dry (three…
Removal Procedure Start By: A.Remove the turbocharger. Refer to Disassembly and Assembly, “Turbocharger – Remove”. 1.Remove bolts (1), locks (3), exhaust manifold (2), and the…